Turning Linear Cylinder

The LOE40 turning electric cylinder is a servo motor-driven linear actuator engineered to deliver steady push & pull linear movement for equipment with tight installation space constraints. Its unique turning fold-back layout breaks the length limitation of traditional straight actuators, perfectly matching multi-angle layout demands of small automated machinery.

Smooth Operation

High-precision ball screw with synchronized transmission ensures continuous motion and minimal start-stop impact.

Low Maintenance

Sealed housing with pre-lubricated components allows long-term operation without daily maintenance.

Flexible Mounting

Standardized front, rear, and trunnion interfaces allow for versatile orientation to suit multi-axis machine layouts.

Small Automation Equipment

Micro assembly units / compact conveyors / tight workstations.

Precision Control Equipment

Positioning platforms / fine adjustment mechanisms / light-duty pressing systems.

Testing & Lab Equipment

Force testing rigs / motion simulation devices.

Production Equipment

Packaging systems / medical devices / handling and clamping units.

1.Rolling contact structure cuts friction loss drastically, operating temperature stays low even under long-hour high-frequency cycles
2.Built-in preload structure eliminates internal clearance, supporting micro-level repeated positioning that lead screws cannot reach
3.Hardened screw surface resists abrasion, service life is 3–5 times longer than common lead screw actuators under identical working conditions
4.Output thrust remains stable without attenuation after thousands of hours of continuous reciprocating movement

This model abandons intermediate transmission components like gears and timing belts, directly coupling the servo motor to the ball screw shaft:
1.No transmission clearance causes positioning deviation, precision remains consistent at low, medium and high speeds
2.Smaller overall motion inertia brings faster response speed, shortening production cycle time
3.Fewer wearing consumables cut later operation and replacement costs for your factory
4.Energy loss during power transmission is minimized, helping lower long-term electricity consumption

1.The folded motor design shortens the overall body length significantly, solving the space shortage problem of narrow equipment cabinets
2.Rotatable motor mounting position supports upward, downward and lateral layout, free to match different machine frame structures
3.Integrated thickened housing enhances overall rigidity, effectively preventing bending deformation under full rated thrust to sustain stable positioning accuracy

Multiple adjustable parameters to match your exclusive automation demands:

• Magnetic limit switch quantity & signal mode customization

• Transition front cap, special flange and trunnion mounting brackets available

• Custom anti-rust coating and IP protection level upgrade

• Travel stroke: 10–600mm, non-standard special stroke customizable

• Ball screw precision: C7 standard grade / C5 grinding high precision

• Drive power: Optional 200W / 400W servo motor

• Screw lead selection: 5mm / 10mm pitch for different speed-thrust demands

• End connection fittings: External thread / Internal thread / Spherical plain bearing / Y hinge

 

 

 

Q1: Can it replace pneumatic cylinders?
A: Yes, for electrically controlled motion systems.

Q2: Is it suitable for continuous operation?
A: Yes, designed for industrial duty cycles.

Q3: Is installation complicated?
A: No, standard interfaces simplify setup.

Q4: How to select a model?
A: Based on force, stroke, and space requirements.

Q5: Does it require frequent maintenance?
A: Maintenance requirement is low.

Hot Tags: turning linear cylinder, China turning linear cylinder suppliers, factory, electric hydraulic ram, Direct connect Electric Linear Cylinder, electric servo cylinder, micro servo linear actuator, 12v electric hydraulic cylinder, Electric Mini Actuators